(Note: Steps 1-6 must be completed within 30 seconds. The entire procedure must be completed within 5 minutes)
1. Start with the ignition key in the off position and the window open.
2. Turn the iginition key to the ON position.
3. Press the front window switch to the auto position six times (Auto up or Auto down).
4. Turn the ignition switch to off position and make sure the door is open.
5. Press the front window switch to the auto up position six times (Auto up or Auto down)
6. Turn the ignition key to the ON position and close the door. The window glass will move down-up-down-up, which indicates that the window motor is in reset mode.
7. Pull and hold the window switch to the UP position until the glass stalls into the upper header seal.
8. Momentarily press the window control switch to the DOWN position and release. The window will carry out a one-touch operation until the glass stalls at the bottom of travel.
9. Pull and hold the window switch to the UP position until the glass stalls into the upper header seal. Continue to hold the switch until it carries out and down-up movement. This movement (approximately 2-3mm) indicates that the motor has been successfully reset.
10. Repeat if necessary.